Description

Buy Shure ULXP14 Instrument Wireless System online in India – India’s music equipment superstore.

Shure ULXP14 Instrument Wireless System.

The Shure ULXP 14 Instrument Wireless System features a ULXP4 Diversity Receiver, a ULX1 Bodypack Transmitter, and the WA302 cable. Shure ULX Standard UHF systems represent a breakthrough in performance and price for both working musicians and professional sound installers. ULX Professional systems offer more advanced features and controls, including lockable settings and group scan function. Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel.

Shure ULXP14 Features:

Automatic Frequency Selection with group scan function
Over 1400 selectable frequencies
Predictive Diversity
5-segment transmitted audio signal strength meter
5-segment RF meter
3-segment transmitter battery fuel gauge
Advanced multi-function LCD displays group and channel
Mic/Line switch
Remotable 1/2-wave antenna
Frequency and volume lockout
XLR and 1/4-inch output
Rugged metal chassis
1/2 rack design.

Shure ULXP14 Specifications:

ULXP4 Wireless Diversity Receiver
RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
used). Refer to the frequency supplement supplied with the system.
Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
ULXP4 Receiver Input
Connector: Antenna Power Input
Connector Type: BNC IEC 320
Actual Impedance: 50 Ohms
Nominal Input Level: —95 to —30 dBm 15 VDC
Maximum Input Level: +6 dBm (—20 dBm recommended) 18 Vdc
Pin Assignments: Shell = Ground Center = Signal IEC Standard
Voltage for Remote Power: 12 Vdc, 150 mA maximum
ULXP4 Receiver Output
Connector: High Z Audio; Low Z Audio
Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
Transmitter Gain Adjustment Range: ULX1: 25 dB
Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): +3.9 dBV (line), —17 dBV (mic)
1/4 inch connector (into 3000 ohm load): —2 dBV
Impedance
ULX1 (input): 1 Megohm ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.
RF Power Output: ULX2: 30 mW maximum
Dynamic Range: >100 dB, A-weighted
RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
Image Rejection: 80 dB typical
Spurious Rejection: 75 dB typical
Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 – 18 Vdc (negative ground), 550 mA
Battery Life: 8 to 9 hours (9V alkaline battery not included)
Operating Temperature Range: – 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
NOTE: Battery characteristics may limit this range.
ULXP4 Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.88 in. (43 mm x 214 mm x 172 mm)
ULXP4 Weight: 2 lbs 7 oz. (1105 g)
ULX1 Dimensions (H x W x D): 3.86 x 2.68 x 1.10 in. (96.5 x 67 x 26.7 mm)
ULX1 Net Weight: 79 g (2.8 oz.) without battery.